What to do if my ATN Mars 2 Riflescope does not switch on?
If your ATN Riflescope does not switch on, first ensure the battery is correctly installed. If it is, the battery may be dead and needs replacing. Also, check the battery contact surfaces for dirt or corrosion; clean them with a pencil eraser or alcohol and cotton swabs. If none of these steps work, the image tube may be defective, requiring service center attention.
Why does my ATN Mars 2 affect boresight after installation or during the firing?
If your ATN Riflescope affects boresight after installation or during firing, it could be due to a loose scope mounting system. Ensure you tighten the fixing nuts securely with a screwdriver. If this doesn't resolve the issue, the factory alignment may be broken, requiring you to send the scope to the service center.
What to do if I cannot achieve the sharp image of the object with my ATN Riflescope?
If you cannot achieve a sharp image with your ATN Riflescope, start by thoroughly cleaning the objective and output lenses. If the problem persists, the optical components may be damaged, requiring you to send the scope to the service center.
Key safety guidelines for handling, operation, and storage to prevent damage and ensure safe use.
Step-by-step guide for mounting the ATN Mars Riflescope and optional accessories onto a weapon.
Instructions on using the scope's controls, battery installation, operation, and shutdown.
Procedures for daily and post-use inspections to ensure the scope is ready and identify potential issues.
Provides a guide to diagnose and resolve common problems with scope operation and performance.
General| Brand | ATN |
|---|---|
| Model | Mars 2 |
| Category | Riflescope |
| Language | English |
To Next Page
