Atomic DRZ - Page 15

P.13
8. Please note that, not all transmier has this funcon. Please refer
to transmier instrucon manual.
9. If you are not familiar with dri gyro operaon:
we recommend to test and setup the car without ch.3 connected.
It is easier to get start, because advance transmier funcon is not
easy to understand. Tunning with physical gyro gain buon is easier
than setup thru transmier screen setup manual.
LED light status :
1. When power it on, LED fast blink means the gyro is doing inializaon
and reading the steering midpoint. Don't move the gyro nor touch the
steering wheel on transmier.
2. (Ch 3 cable connected)
LED steady light aer inializaon, means the gyro is receiving sensivity
signal from transmier. Gyro gain is set by transmier Ch 3 dial.
And gyro compensaon steering angle is set on gyro (limit) knob.
3. (Ch 3 is not connected) --LED blinks slowly when inializaon completed,
means no sensivity signal received from transmier, gyro gain is seng
with adjustment knob on the gyro. (servo angle is set at maximum )