P.12
Instrucons:
1. Use thick double side tape to fix the gyro (on the center line of chassis )
thicker tape (2mm or more) has beer vibraon absorpon and the gyro
will perform beer.
2. Switch1: Adjust the “switch to make sure the servo is “REV – NOR”
working in correct direcon. Set to if using stock servo on DRZ.“REV”
3. Switch2: Adjust the switch for type of servo, Atomic servos are “AN-DG”
Digital type- “DG”
4. Un-plug the Ch.3 cable, and adjust the gyro gain knob to (middle).50%
5. Power on the car and transmier, don’t touch the car and transmier
during gyro inializaon. Aer inializaon, the car is ready to dri.
6. Decrease the gyro gain if the servo is shaking. Normally 45 to 50% gain is
a sweet spot for dri.
7. If your transmier has “ch.3 dial or adjustment” funcon, you can
connect Ch.3 cable to receiver and adjust gyro gain value thru transmier.
To Next Page
Loading...
