Atomic G05214W - Assembly - Section 4; Step 7: Apron Installation; Step 8: Cord Hole and Pivot Bushing

PARTS REQUIRED
1 pc - P17 Outer Apron with Cord Hole
1 pc - P18 Outer Apron without Cord Hole
STEP 7:
To install P17 Outer Apron with Cord Hole, please feed the cord plug end back inside the hole in side apron.
Carefully insert and sleave P17 Outer Apron with Cord Hole and P18 Outer Apron without Cord Hole as shown in
FIGURE 7.
P17
P18
FIGURE 7
STEP 8:
Feed the plug end again through the hole in the side apron as shown in FIGURE 8A.
Attach P21 Round Plastic for Cord Hole as shown in FIGURE 8B.
Install four (4) pcs H20 Screws on each end of the side apron as shown in FIGURE 8B.
Insert P25 Female Pivot Bushing onto each H10 Male Pivot Assembly on each end of table as shown in FIGURE 8B.
NOTE: The P25 is not permanently attached until STEP #10.
PARTS REQUIRED
4 pcs - H20 Phillips Flat Head Screw 1 pc - P21 Round Plastic for Cord Hole
2 pcs - P25 Female Pivot Bushing
Cord Plug
FIGURE 8A
Cord Plug
FIGURE 8B
8
© 2013 Escalade Sports
For Customer Service Call 1-886-996-2729
All Right Reserved.
P21
White laminate
face outside.
White laminate
face outside.
IMPORTANT NOTE:
End of P17 & P18 Outer Apron must be
flush with table end apron.
IMPORTANT NOTE: Do not run cord through side
pocket holes. Please use the holes directly beside
the side pocket.
H20
H20
H20
H20
IMPORTANT NOTE:
This hole is offset and
must match this hole.
Note: Pilot Holes
H10
P25
P25