Watch Not Receiving Time Signal:
Reasons for not being able to receive the Time Signal include:
-Being outside of the United States
-Being in a built up area
-Metal objects blocking the radio signal
-Interference from computer monitor or TV
Depending on your location in the United States, if east of Colorado, you must locate a west
facing window. If west of Colorado, you must locate an East facing window.
Ensure that the watch is set by a window, as this provides the best reception; you may have to try
different windows in the house to see which is best. Please not that reception is always better at
night. If your watch is unable to receive the radio signal, it will continue to function in the same
way as a standard watch. The time will then be corrected the next time your watch receives the
time signal.
Battery Replacement:
This watch uses a CR2025 type battery; trained jewelers or watch specialists should replace the
batteries to avoid damage to the watch.
1. Open and carefully remove the back of the watch.
2. Lift up the battery spring on the right.
3. Remove the battery and insert a new one with the polarity “+” facing up.
4. Push the battery spring down.
5. Before you replace the case-back, make sure the seal is in place.
The watch does not run after a new battery is replaced until the following initiation has been
done:
Set the hands and initialize the electronics.
All hands (hour, minute, and second-hands) have to be moved to the 12 o’clock position
(12:00:00) to initialize after battery change. The watch will not run until re-initialized.
1. Immediately after battery has been replaced hold 2 o’clock button until the hands move
quickly. You can stop the fast movement by pressing 2 o’clock button again.
2. Stop the fast movement before the second-hand reaches the 12 o’clock position
(11:58:00) by pressing the 2 o’clock button.
3. Adjust the second- hand one-second at a time to move it to the 12 o’clock position
(12:00:00) by pressing 2 o’clock button. (If you accidentally go past the 12, start this
process again.)
4. When all hands are aligned at the 12 o’clock position (12:00:00), PUSH 10 o’clock
button for 1 second to confirm.
To Next Page
Loading...