ATOMSTACK B3 - Create Positioning Marks for Alignment; Move Laser and Capture Alignment Image; Mark Alignment Cross Points Sequentially; Finalize Alignment Calibration

09
3.3.5 Click "Sta" to make positioning marks. 3.3.6 After engraving is complete, click on position 1 below to move the
laser to the upper position to avoid obstructing the engraved pattern. Click
on Capture Image at position 2, and then click on 3.
3.3.7 Click on the cross points in the order of numbers 1-4.
First, enlarge the pattern at position 1 to the maximum and
double-click on the cross point. If there is an obvious oset in
the double-clicked cross, you can click on position 2 in the
image below or any blank position, and then reselect and
double-click on the cross point.
3.3.8 Click "Finish."