ATOMSTACK B3 - Position Pattern and Start Engraving; Review Engraving Results; 3.5 How to Record a Video; Turn Off Camera Control

11
3.4.2 Move the engraving pattern to the desired location,
set the engraving parameters, and click "Sta."
3.4.3 After engraving is complete, see the results below.
3.5 How to Record a Video
3.5.1 Select "None" in the camera control to turn o the camera.
3.5.2 Enable the system's camera. For Windows systems, if
recording is within 3 hours, use the built-in camera, otherwise, it
is recommended to download free recording software such as
PotPlayer. For macOS systems, it is recommended to use Camera
Record-Video Recorder or Quick Player.