ATOMSTACK B3 - Resume Engraving After Opening Box Cover

LightBurn and LaserGRBL will display the following code prompts: "[MSG:Check door][MSG:PreviousPage:1]";
LightBurn prompt
LaserGRBL prompt
2.3.2 If the box cover is opened during the engraving process, the engraving machine will automatically pause and will resume engraving when
the box cover is closed, until completion.
2.3.3 How to Continue Engraving Normally after Opening the Box Cover
1）In the case of oine engraving and wanting to open the box cover to obsee the engraving, you can open the box cover and then click the
resume key on the display screen, and the machine will continue engraving. Closing the box cover will not aect the engraving process.
99%
100
100
03