ATOMSTACK B3 - Page 6

3) In the case of engraving with LaserGRBL and wanting to open the box cover to obsee the engraving, you can open the box cover to pause
the engraving machine, then click the " " in the bottom right corner of the software. The machine will continue engraving. Closing the box
cover will not aect the engraving process.
2）In the case of engraving with LightBurn and wanting to open the box cover to obsee the engraving, you can open the box cover to pause
the engraving machine, then click pause in LightBurn and after 5 seconds, click resume. The machine will continue engraving. Closing the box
cover will not aect the engraving process.
04