BATTERIES REPLACEMENT
TROUBLESHOOTING
Fault code Fault Cause Solution
E1 The heater overheating Call after-sales service.
E2 NTC is defective. Call after-sales service.
E3 The heater not working.
If the vents are dirty or clogged. Unplug the power,
clean the dust and debris of the vent area. Wait for 5
minutes, plug in and turn on the heater. If the heater
still don't work, please call after-sales service.
8
1. Turn the remote control over, and locate the battery cover.
Battery Cover
2. Remove the battery cover by sliding it towards the bottom end of the remote control.
3. Insert two AAA batteries into the battery socket, the battery has two poles(positive and negative),
the flat side is negative pole, make sure the batteries are firmly seated into the remote control.
4. Reinstall the battery cover, making sure it clicks into position.
NOTE: Do not use old and new batteries together !
To Next Page
Loading...