Purificare ©2015
9
Lamp Status Indicator
DWS © 2019 • www.aquat.com
To Find out how many Months are left on the Lamp Timer - Push the reset button for 1-2 seconds then release. After
an initial sound there will be a pause followed by beeping and a flashing LED. The number of beeps corresponds the
number of months left on the lamp life.
To Reset 1 Year Lamp Timer – WHEN REPLACING THE U.V. LAMP. Unplug the control box from the wall outlet.
Unplug the U.V. lamp from the Lamp connector. Replace with a new U.V. Lamp. Make sure the control box is plugged
into the wall outlet and the U.V. lamp is on. Press and hold the reset push button. A tone that descends in frequency once
per second will be heard. Hold the reset button down for approximately 5-8 seconds until you hear a continuous tone. At
this point release the button. The 1 year timer has just been reset.
LAMP STATUS INDICATOR / U.V. LAMP ADVISOR:
NOTE: During normal operation, the Green LED will ash every 5 - 10 seconds.
Please contact your local dealer for replacement UV lamps.
Refer servicing to qualied service personnel.
To Next Page
Loading...