EasyManua.ls Logo

ATX 24 Type-S - Page 90

Default Icon
100 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
CARE AND MAINTENANCE
|
89
10. Prepare the engine for storage according to the instructions contained in
the engine owner’s manual.
11. Store the bilge drain plug and any other drain plugs removed in a plastic
bag and tape it to the throttle control lever or near the dash so it is easy to
find after being stored.
12. Remove the battery from the boat. Clean, fully charge and store the
battery in an area not subject to freezing temperatures or directly
on cement. DO NOT store batteries close to heat, spark or flame-
producing devices.
13. Repack trailer wheel bearings with water-resistant wheel bearing
grease. If the trailer is equipped with bearing protectors, apply grease into
hubs with a grease gun.
14. Park trailer and boat in a protected area on cement if possible. If your
boat and trailer are left outside, install a boat cover. Cover the boat with
the storage cover. If a temporary poly cover such as shrink wrap is used,
your ATX Dealer will install vents to provide ventilation to help prevent
mold or mildew.
15. Loosen tie-downs and winch line, but make sure the boat is resting
properly on hull supports.
16. Jack up trailer and place blocks under trailer frame to relieve weight on
trailer tires and springs.
NOTICE
DO NOT use your tonneau cover or bimini top for long-term storage. These
are not designed for long-term storage and do not provide good protection.
Adequate ventilation is not possible and mold/mildew will form. For more
information on appropriate long-term storage, see your ATX Dealer.
What to do after Boat Storage
Have your ATX Dealer prepare your boat for the next boating season. It is very
important for the fuel system and exhaust system to be thoroughly inspected and
repaired, if necessary, before operating the boat.
There are many steps required to ensure your boat is in proper operating
condition. Avoid the risk of fire or explosion. Inspect the fuel system. Failure to
inspect the fuel system and allow fuel leaks to go undetected will contribute to a
fire or explosion hazard.
If your swim platform was removed for storage, reinstall it. The removable feature
is for boat storage only. The boat must not be operated without the swim platform.
WARNING
FIRE OR EXPLOSION HAZARD
Fuels are extremely flammable and highly explosive under certain
conditions. DO NOT smoke or allow open flame or sparks nearby when
inspecting the fuel system.

Table of Contents

Related product manuals