Chapter 2
Quick start guide
This chapter guides you through the setup process for a basic project where an APM1xx paging
microphone gets connected to a matrix system or relay unit. Make sure the system power is switched
off when connecting.
ATTENTION
Making or changing any connections while powered-on can lead to permanent
damage of the equipment. Make sure the power is switched off while connecting
and verify correct connection method before powering on!
Connect the the APM1xx paging microphone to a matrix system or Audac relay unit using cabling CAT
(CAT5E for analog systems and CAT6 for digital systems) with a standard cable length of 300 meters.
Make sure the APM1xx is connected to the appropriate input (paging or peripheral input connection). If
any doubt refer to the user manual the APM is to be connected to.
To Next Page
Loading...