After the connections are made and verified, the system is ready to be switched-on.
When power is applied to the APM, it is instantly ready for operation. In standard (factory default)
mode, a software configuration for use in combination with ARU relay units is pre-loaded. When
used in combination with digital systems, a custom configuration needs to be made.
A custom configuration can be made in different ways. The most common way is by using
the webinterface of the connected matrix, allowing configuration of the most commonly used
functions. Another method is by using the Audac system manager tool, which can be freely
downloaded and allows for more complex configurations than those available from the web
interfaces. Detailed configuration guides of how the custom configuration should be made, can be
found in the instruction manual of the related Matrix or Audac system manager.
After the configuration has been made successfully, the system is ready for operation.
When pressing a zone selection button, the zone will be activated and the corresponding button
will illuminate in orange colour. When pressing again, the zone will be deactivated. Multiple (All)
zones can be instantly activated by selecting the ‘Select all’ button and can be deactivated by
pressing ‘Clear all’.
To Next Page
Loading...