Audeara A-01 User Manual

3. ACTIVATE DISCOVERY MODE
In order to pair the headphones with
your device, you must irst put them
in to discovery mode. You must be
using Bluetooth to create your hearing
proile through the Audeara app.:
1. TURN HEADPHONES ON
Turn headphones on by licking the
power switch up on the left ear cup.
The blue indicator LED will start lashing.
2. ACTIVATE PAIRING
Hold down the multifunction button
for three seconds. The LED indicator
will start lashing blue and red and you
will hear the headphones say “pairing
mode active”.
1. CHARGE THE BATTERY
1. INSERT CABLE
Connect the headphones to
a USB power source to charge
the internal battery. Time to
fully charge is 6 hours.
2. CHARGING
While the headphones are
charging, the LED indicator
will be RED.
3. FULLY CHARGED
When charging is complete,
the LED indicator will be BLUE.
Note: You will be unable to listen to your headphones while they are charging
due to International Safety regulations.
audeara.com
Power
on/o switch
Multifunction
button
A  01
Quickstart Guide

Audeara A-01 Specifications

General

Type	Over-ear
Frequency Response	20Hz - 20kHz
Impedance	32 ohms
Bluetooth	Yes
Driver Size	40mm
Microphone	Yes
Connectivity	Wired/Wireless
Noise Cancellation	Active Noise Cancellation (ANC)

Summary

Charge the Battery

Insert Charging Cable

Connect headphones to a USB power source for charging. Full charge takes 6 hours.

Charging Indicator Status

The LED indicator is RED while charging and turns BLUE when fully charged.

Activate Discovery Mode

Turn Headphones On

Flick the power switch up on the left ear cup. The blue indicator LED starts flashing.

Activate Pairing Mode

Hold the multifunction button for three seconds. LED flashes blue/red, voice confirms "pairing mode active".

Pair Your Device

iOS Pairing Steps

Go to Settings > Bluetooth. Tap "Audeara A-01" to pair. LED stops flashing and remains blue.

Android Pairing Steps

Go to Settings > Connections > Bluetooth. Tap "Audeara A-01" to pair. LED stops flashing and remains blue.

Personalise Your Headphones

Support and Feedback

Product Safety Information

Regulatory Compliance

FCC and IC Statements

Device complies with FCC Part 15 and Innovation, Science and Economic Development Canada's licence-exempt RSS.

FCC Interference Statement

Equipment tested for Class B limits; may cause interference if not installed per instructions.

RoHS Compliance

Product complies with EU Directive 2011/65/EU on hazardous substances.

IC Compliance Statement

Device contains licence-exempt transmitter(s)/receiver(s) compliant with CNR.

WEE Notice

Proper disposal of waste electrical equipment for environmental protection and resource conservation.