EasyManua.ls Logo

Audi A4 2013 - Page 185

Audi A4 2013
302 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
_& WARNING
Improper installation of child restraints
will increase the risk of injury and death in
a crash.
- Always follow the instructions provided
by the manufacturer of the child re-
straint you intend to install in your Audi.
- Improper use of child restraint anchors
(including tether anchors) can lead to in-
jury in a collision. The anchors are de-
signed to withstand only those loads im-
posed by correctly fitted child restraints.
- Never mount two child restraint systems
on one LATCH lower anchor point.
- Never attach two child restraint systems
to one tether strap or tether anchorage.
- Never attach a tether strap to a tie-down
hook in the luggage compartment.
- Never use child restraint tether ancho-
rages to secure safety belts or other
kinds of occupant restraints.
- Never secure or attach any luggage or
other items to the LATCH lower ancho-
rages or to the tether anchors.
- If a tether or other strap is used to at-
tach a child restraint to the front passen-
ger seat, make sure that it is not so
tight , that it causes the weight-sensing
mat to measure more weight than is ac-
tually on the seat.
- The heavier weight registered can make
the Advanced Airbag System work as
though an adult were on the seat and de-
ploy the Advanced Airbag when it must
be suppressed causing serious or even
fatal injury to the child.
- If you must install a rearward facing
child safety seat on the front passenger
seat because of exceptional circumstan-
ces and the
PASSENGER AIR BAG OFF
light does not come on and stay on, im-
mediately install the rear-facing child
safety seat in a rear seating position and
have the airbag system inspected by your
Audi dealer.
Child Safety 183
Installing the upper tether strap on the
anchorage
Fig. 172 Sedan Tether strap: proper routing and
mou nting
Fig. 173 allroad Tether strap: proper rout ing and
moun ting
Installing the tether strap
.,. Release or deploy the tether strap on the
child restraint according to the child re-
straint manufacturer's instructions .
.,. Guide the upper tether strap
under the rear
head restraint ~
fig . 172 or ¢ fig. 173 (raise
the head restraint if necessary).
.,. Sedan: Tilt the recess flap up to expose the
anchor bracket.
.,. Sedan: Attach the tether strap anchorage
hook into t he opening of the tether anchor-
age .
.,. allroad: Slide the tether strap hook over the
anchor bracket.
.,. Pull on the tether strap hook so that the
spring catch of the hook engages .
.,. Tighten the tether strap firmly following
the child restraint manufacturer's instruc-
t ions.
Releasing the tether strap
.,. Loosen the tension following the child re-
straint manufacturer's instructions .
1J1-

Table of Contents

Related product manuals