5 6 Clear v ision
Attach ing th e wiper blade
.,. Press the wiper blade holder in the arrow d i-
rection ¢
fig. 55 into the mount.
.,. Fold the windshield wiper arm back onto
the windsh ie ld.
A WARNING
- If the windshield wipers smear the wind-
shield, clean the wiper blades with wind-
shield washer fluid. If the wiper blades
are extremely d irty, you can also clean
them with a soft sponge or cloth.
- For safety reasons, the windsh ield wiper
blades should be replaced once or twice
each year.
Digital compass
Switching the compass on and off
Applies to vehicles: with digita l compass
The compass direction is shown in the rear-
view mirror.
NI--I
Fig. 56 Rearview mirro r : Digital compass act ivated
.,. To switch the compass on or off, press and
hold the button @ until the compass dis-
play in the mirror ¢
fig. 56 appears or d isap -
pears .
The digital compass only works when the igni-
tion is on . The directions are indicated with
abbreviations :
N (north), NE (northeast), E
(east), SE (southeast), S (south), SW (south-
west),
W (west), NW (no rthwest).
(D Tips
To prevent inaccurate compass readings,
do not bring any remote controls, elect ri-
ca l devices or metallic objects near the
mirror .
Adjusting the magnetic zone
Applies to vehicles: with digital compass
The magnetic zone must be adjusted correctly
for the compass to read accurately.
Fig. 5 7 North America: magn etic deflect ion zone
boun daries
"'
.,. Press and hold the button @ ¢ fig. 57 unt il
the number of the magnetic zone appears in
the rearview mirror .
.,. Press the button @ repeatedly to se lect the
correct magnetic zone . The se lect ion mode
t urns off after a few seconds .
Calibrating the compass
Applies to vehicles: with digital compass
You must recalibrate the compass if it does
not display the correct direction.
.,. Press and hold the button @ until a C ap-
pears in the rea rview mirro r.
.,. Drive in a circle at about 6 mph (10 km/h)
until a d irection is displayed in the rea rview
mirror.
II>-
To Next Page
Loading...
