264 What do I do now?
- Check the tire pressure on the spare imme-
diately after installation.
- Have the wheel bolt tightening torque
checked with a torque wrench as soon as
possible by your authorized Audi dealer or
a qualified workshop.
- With steel and alloy wheel rims, the wheel
bolts are correctly tightened at a torque of
90 ft lbs . (120 Nm).
- If you notice that the wheel bolts are cor-
roded and difficult to turn while changing
a tire, they should be replaced before you
check the tightening torque .
- Replace the flat tire with a new one and
have it installed on your vehicle as soon as
possible. Remount the wheel cover.
Until then, drive with extra care and at re-
duced speeds .
A WARNING
- If you are going to equip your vehicle
with t ires or rims which differ from t hose
which were facto ry installed, th en be
sure to read t he informati on ~
pag e 24 6,
New tires and replacing tires and
wheel s.
- Always make sure the damaged wheel or
even a flat tire and th e jack and tool kit
are properly secure d in th e luggage com-
part ment and are not loose in the pas-
senger compartment .
- In an accident or sudden maneuver they
could fly forward, injuring anyone in t he
vehicle.
- Always store damage d wheel, jack and
tool s secure ly in the luggage compart -
ment . Otherwise, in an accident or sud-
den maneuver they could fly forward,
causing injury to passenge rs in the vehi-
cle.
@ Note
Do not use commerc ially available t ire
sea lants. Otherwise, the elect rical compo-
nents of the tire pressure mon itor ing sys-
tem* will no longer work properly and the
sensor for th e tire pressure monito ring
system * will have to be replaced by a
qualified workshop.
To Next Page
Loading...
