26 Dr iv er in f ormation d is play
¢ fig. 10 . The data from the single -trip mem -
ory (memory leve l 1) is being displayed if a
D
appears in the display . If a II is shown, then
the data from the total -trip memory is being
displayed (memory leve l 2). The fuel pump
nozzle
iii indicates the efficiency program*
¢ page 27 .
Single-tr ip memory (Trip computer 1)
The single-trip memory stores the trip infor-
mat ion from the time the ignition is turned o n
until it is turned off. If the trip is continued
within 2 hours from the t ime the ignition was
turned off, the new data will be included in
the calcu lation of the current trip info rma-
tion .
If the t rip is inte rrupted fo r more than 2
hours the memory is reset automati ca lly.
Total -trip memory (Trip computer 2)
Unlike the sing le-trip memory, the tota l-tr ip
memory is not reset automatically . This per-
mits you to evaluate your driving data for the
enti re pe riod be tween manual rese t s.
Efficiency program*
The effic iency program can help you to use
less fuel ¢ page 2 7.
Operation
App lies to vehicles: with trip computer
The trip computer is controlled by two
switches on the windshield wiper lever.
Fig. 11 Windshiel d wiper lever: controls for th e t rip
computer
M
"'
0
N
"'
co
a:,
~
To disp lay the trip computer memory levels ,
press the I RES ET I button @ ¢ fig. 11 re-
peatedly unt il the desired memory leve l is
shown in the d isplay .
~
To display tr ip informat ion wit hin a memory
level, press the top or bottom part of the
function se lection switch @ .
The t rip computer will not ope rate un less the
ignition is on. When you t urn on the ignition,
the function that was in use when you last
turned the ignition off will be displayed .
In add ition to info rmation on the t rip comput -
er (trip computer 1 and 2 and the efficiency
program *), t he digital spee dometer and infor-
mation regard ing the navigat ion system* can
also be displayed. To switch the disp lay be-
tween the different information, tap the
I RESET ! button @ briefly.
Sett ing values to zero
To de lete one current value from the trip com -
puter, se lect the des ired funct ion and press
t he I RES ET I button @ for at least one second.
The following values can be set to zero indi-
vidually:
- Average fue l mi leage
- Average speed
- Elapsed t ime
- Dist ance
All cur rently d isplayed values are deleted in
the eff iciency program*.
In add it ion,
all the values in the single-trip or
the total-tr ip memory can be de leted simulta-
neously ¢ page 26.
(D Tips
All stored va lues will be lost if the veh icle
battery is discon nected .
Basic Settings for the trip computer
Applies to vehicles: with trip computer
The radio or MMI* operating unit is used for
setting the trip computer's basic settings.
~
Select: Function button ICAR ! > Instrument
cluster > On-board computer 1 or On-board
computer 2 . .,.
To Next Page
Loading...
