4 8 Clear v ision
@ Tips
- The light sensor* for headlight control is
located in the rear view m irror mount.
You should therefore not apply any st ick-
ers to the windsh ield in this area in order
to prevent malfunctions or failures.
- Some exterior lighting functions can be
adjusted
c> page 48.
- When you remove your key from the igni-
tion while the vehicle's lights are turned
on, a buzzer sounds as long as the driv-
er's door is open .
- In cool or damp weather, the ins ide of
the headlights, turn signals and tail
lights can fog over due to the tempera-
ture difference between the inside and
outside. They will clea r s hor t ly after
switching t hem on. This does not affect
the service life of t he lighting.
- In the even t of a light sensor malfunc-
tion, the driver is not ified in t he instru-
ment cluster disp lay ¢
page 22.
Turn signals and high beam lever
The lever operates the turn signals , the high
beams and th e headlight flash er.
Fig. 4 1 Turn signal and high beam l ever
Turn signals ¢i ¢
The turn signals activate when you move the
lever into a turn s ignal pos ition when the ign i-
tion is switched on.
(D - right turn signal
@ - left tur n signa l
The turn s ignal blinks three times if you just
tap the lever .
High beams and headlight flasher [D
Move the lever to the correspon ding posit io n:
@ - high beams on
@ - high beams off o r headligh t fla s her
The indicator light II in the instr ument clus-
ter turns on .
Not es on thes e features
- The turn signals on ly work w ith the ign ition
t ur ned on. The indicator lights
B or II in
t he instrument cluster also blink.
- After you have turned a corner, the tu rn sig-
na l switches off aut oma t ically.
- The
high beam works on ly when the head-
lights a re on. The indicator light
II in t he
instrument cluster illuminates when the
high beams are on .
- The
headlight flasher works only as long as
you ho ld the lever - even if the re a re no
lights switched on . The ind icator light
II in
the instrument cluster illum inates when you
use the headlight flasher.
A WARNING
- -
Do not use the high beam or headlight
flashe r if you know that these could blind
oncom ing traffic.
Adjusting exterior lighting
The functions ore selected in the radio or
MMI" .
.,. Select: I CAR ! function button > Exterior
light ing.
Or
.,. Select: !CAR I function button > Car sys-
tem s*
contro l button > Vehicle settings >
Exterior lighting .
Coming home (light when leaving car}* ,
Leaving home (light when unlocking car)*
The coming home function illuminates the
area around the vehicle when the ignition is
switched off and the dr iver's door is opened .
Depend ing on vehicle equ ipment, the function
can be switched on and off or the length of
time the lights remain on* can be adj usted . ..,_
To Next Page
Loading...
