Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
1.3 Overview - Selector Mechanism
Selector Mechanism
WARNING
There is a risk of injury and accident from accidentally engag‐
ing a gear when the engine is running.
1 - O-Ring
❑ Replace after removing
2 - Selector Lever Cable
❑ Do not bend
❑ Removing and instal‐
ling. Refer to
⇒ “1.9 Selector Lever
Cable, Removing and
Installing”, page 25 .
3 - Bolt
❑ For selector lever cable
adjustment
❑ Tightening specification
-item 6-
⇒ Item 6 (page 12) .
4 - Transmission Park Selector
Switch - F305-
❑ Consists of two micro-
switches on the circuit
board on the Shift Lock
Solenoid - N110- .
❑ Can only be replaced to‐
gether with the Shift
Lock Solenoid - N110- .
Refer to
⇒ “1.11 Shift Lock Sol‐
enoid N110 , Removing
and Installing”,
page 32 .
5 - Shift Lock Solenoid - N110-
❑ Removing and instal‐
ling. Refer to
⇒ “1.11 Shift Lock Sol‐
enoid N110 , Removing
and Installing”,
page 32 .
6 - Cap
❑ Via the Shift Lock Solenoid - N110-
7 - Selector Lever Sensor System Control Module - J587- with Tiptronic Switch - F189-
❑ Removing and installing. Refer to
⇒ “1.12 Selector Lever Sensor System Control Module J587 , Removing and Installing”, page 34 .
8 - Nut
❑ 8 Nm
❑ Quantity: 4
❑ For securing the shift mechanism to the body
Audi A6 2011 ➤ , Audi A6 Avant 2011 ➤ , Audi A7 Sportback 2011 ➤ , Audi ...
7-Speed Dual Clutch Transmission 0CK - Edition 11.2015
14 Rep. Gr.34 - Controls, Housing
To Next Page
Loading...
