For vehicles equipped with adaptive cruise assist*, the system is a combination of speed and distance regulation and helps
maintain a distance from a vehicle driving ahead. Adaptive cruise assist can brake and accelerate as necessary to help
maintain the selected distance.
• To activate, set, change, cancel or resume cruising speed, follow the same instructions as listed above for standard
cruise control.
The greater the speed, the greater the distance that is needed. To change the set distance:
• Tap the rocker switch to display the current set distance.
• To increase or decrease the distance in increments, tap the switch again toward or .
Lane Guidance
Within the limits of the system, lane guidance* can provide corrective steering to assist the driver with keeping the vehicle
in the center of the lane. Press the button on the turn signal lever to switch lane guidance on or o. Lane guidance is
o when the indicator light is white . Some conditions may deactivate lane guidance, such as no lane lines, lane too
narrow or wide, etc.
Driver Assist Systems
There are three levels of driver assistance systems*: Maximum,
Individual and Basic. Maximum activates all available features.
Individual allows you to select an individual system. Basic activates
only Audi pre sense and emergency assist. To choose, press the Driver
Assistance button on the center console. Or, in the upper display,
select Vehicle Driver assistance. Depending on vehicle equipment,
features may include:
• Night vision assist.
• Distance warning.
• Audi pre sense.
• Side assist.
Cruise Control & Driver Assistance Features
Warnings: Driver Assistance
See Driver Assistance in your Owner’s Manual for more detailed information and for important safety warnings.
• Intersection assist.
• Emergency assist.
• Exit warning.
Upper display shown
*Driver assistance features are not substitutes for
attentive driving. See Owner’s Manual for further details
and important limitations.
Cruise Control
Activate
To activate, pull the control stalk toward you in the ON position.
Set or Change Speed
At your desired speed, press the SET button on the end of the stalk.
The set speed along with respective indicator light is shown in the
instrument cluster.
There are several ways to change your speed:
• Accelerate or decelerate, then press the SET button again.
• Push the stalk up or down one level to increase/decrease speed in 1 mph increments.
• Push the stalk up or down two levels to increase/decrease speed in 5 mph increments.
• Hold the stalk up or down to increase/decrease speed; release when desired speed is reached.
Cancel/Resume
To cancel and resume cruise control:
• To cancel, press the brake pedal or push the stalk briefly away from you one detent to the CANCEL position.
• The indicator light will go o in the instrument cluster.
• To resume, pull the stalk toward you; you will return to your last set speed.
Your most recently set speed remains in memory until you turn cruise control or the ignition o.
To Next Page
Loading...
Need help?
General
