Audi Q5 2008 - Connecting for Measuring and Testing, One Service Connection

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Connect service station via service connections with quick-re‐
lease coupling adapters to vehicle refrigerant circuit.
– Screw in handwheel of quick-release coupling adapters only
until valves are definitely open at refrigerant circuit connection
(observe pressure gauge, do not strain valves).
– Perform planned tests and measurements.
2.4.5 Connecting for Measuring and Testing,
One Service Connection
Special tools and workshop equipment required
♦ Valve Adapters -V.A.G 1785/9-
♦ -V.A.G 1785/10- or Air Conditioning Adapter Set -V.A.G 1786-
• Work procedure may vary depending on the type of tools se‐
lected (the tool-specific operating instructions should therefore
be followed).
Note
The work procedure is always to be performed as described in
the operating instructions for the A/C service station.
The charging hoses are to be connected as follows to prevent the
entry of air or moisture into the refrigerant circuit:
– Switch off the ignition.
– Connect service station to power supply.
– Remove the caps from the service connections or connections
with valve (refer to vehicle-specific refrigerant circuit). Refer to
⇒ Heating, Ventilation and Air Conditioning; Rep. Gr. 87 ;
Removal and Installation (vehicle-specific repair manual).
– Evacuate charging hoses if necessary.
– Connect quick-release coupling to service connection of re‐
frigerant circuit.
WARNING
♦ Never open valves on low or high-pressure side with en‐
gine running. Otherwise, compressor or service station
could be destroyed by a short circuit between high and
low-pressure sides of refrigerant circuit if air conditioning
system is switched on.
– Only tighten the handwheel in the quick-release coupling just
enough so the service connection is open. Watch the pressure
gauge and do not place too much pressure on the valve.
– Start the engine and perform the planned tests and measure‐
ments.
– Compare values determined to specified measured values.
Refer to ⇒ “4.4 Pressures, Checking“, page 153 .
– Before disconnecting quick-release coupling, close it by
screwing out handwheel.
Audi 100 1991 ➤ , Audi 80 1992 ➤ , Audi A1 2011 ➤ , Audi A2 2001 ➤ , A ...
Refrigerant R134a Servicing - Edition 01.2011
84 Rep. Gr.00 - General, Technical Data