– Remove heat shield for drive shaft (right-side) ⇒ Running
gear, axles, steering; Rep. gr. 40 ; Drive shaft; Removing and
installing heat shield for drive shaft .
– Unbolt drive shafts (left and right) from flange shafts of gear‐
box and tie them up ⇒ Running gear, axles, steering; Rep. gr.
40 ; Drive shaft; Removing and installing drive shaft .
Caution
The gearbox control unit (mechatronic unit) can be damaged
by electrostatic discharge.
♦ Before handling electrical connectors, mechanic must dis‐
charge static. To do so, touch vehicle earth, heater radi‐
ator, or lifting platform, with your hand.
♦ Do not touch contact pins in gearbox connector with bare
hands.
– Unplug electrical connectors:
1 - For parking lock solenoid - N486-
2 - For automatic gearbox control unit - J217-
3 - For electric pump 2 for gearbox - V553-
– Move electrical connector -arrow- for all-wheel drive control
unit - J492- clear.
Audi A4 2015 ➤ , Audi A4 Avant 2015 ➤ , Audi A4 China 2016 ➤ , Audi A4 a ...
7-speed dual clutch gearbox 0CJ, 0CK, 0CL, 0DN, 0DP - Edition 08.2018
60 Rep. gr.34 - Controls, housing
To Next Page
Loading...
