– Unscrew plug -arrow- for inspection and filler hole on right side
of gearbox housing using socket Torx T60 - T40087- .
– Slowly fill gear oil (MTF) using hand pump for gear oil - VAS
6617- .
• Gear oil (MTF) specifications ⇒ Electronic parts catalogue
– Repeat the procedure in several steps by adding gear oil
(MTF) every 15 seconds until level is 2 mm below bottom edge
of inspection and filler hole.
Note
Make sure to wait the required amount of time so that the various
oil chambers in the gearbox are filled evenly.
– Tighten plug.
The remaining installation steps are carried out in the reverse se‐
quence.
Tightening torques
♦ Screw plug ⇒ “6.1 Overview - gear oil circuit”, page 77
♦ ⇒ Running gear, axles, steering; Rep. gr. 40 ; Subframe; Ex‐
ploded view - subframe
♦ ⇒ General body repairs, exterior; Rep. gr. 66 ; Noise insula‐
tion; Exploded view - noise insulation
Audi A4 2015 ➤ , Audi A4 Avant 2015 ➤ , Audi A4 China 2016 ➤ , Audi A4 a ...
7-speed dual clutch gearbox 0CJ, 0CK, 0CL, 0DN, 0DP - Edition 08.2018
90 Rep. gr.34 - Controls, housing
To Next Page
Loading...
