a,
a,
.....
N
l"-
N
.....
0
0
0:
co
Operation
The trip computer is controlled by two switches
on the windshield wiper lever.
~------, @
Fig. 16 W indshield wiper lever: cont rols for the tr ip com-
puter
Operating
.,. To display the trip computer memory leve ls,
press the
I RESET ! button @ r:::> fig. 16 repeated-
ly until the des ired memory level is show n in
the d isplay.
.,. To display trip informat ion within a memory
level, press the t op or bottom par t of the func-
t ion select io n switch
@ .
The trip computer will not operate un less the ig-
nition is on. When you t urn on the ignition, the
f unction t ha t was in use when you last tu rned the
ignit io n off will be displayed.
In addition to information abo ut the trip compu t -
e r (trip computer 1, 2 and the effic iency pro-
g ram*), informat ion about othe r systems ca n al-
so be shown in the disp lay. To switch the d isp lay
between the diff eren t informat io n, tap t he
I RESET I button @ briefly.
Resetting values to zero
.,. Se lect a val ue in t he desired tr ip comp ute r o r in
t he effi ciency progra m* .
.,. Press and hold the
I RESET I button @ for at
least one seco nd . All values in t he selected t rip
computer or in the efficiency program* a re re-
set to ze ro.
If t he dat a in tr ip compu t er 1 are deleted, t hen
the values in the efficiency program* will also be
reset .
Driver in f orma t ion system
Wit h some vehicle eq uip ment levels, the value s
for the single trip or tota l trip memory can also
be reset in the radio or M MI*
r:::> page 21 .
(I_) Tips
All stored val ues will be lost if the vehicle bat-
tery is disconnected.
Basic Settings for the trip computer
The MMI* or the radio operating unit is used for
setting the trip computer's basic settings .
.,. Sele ct: !CAR I func t ion button> In strument
cluster > On-board computer 1
or On-board
computer
2.
The values in the sing le-t rip or the tot a l-t rip
memo ry can all be reset to zero at the same t ime
under
Reset in the men u.
In addition, you ca n determine wha t info rm at ion
from the tr ip compu t er should be s hown in the
inst rument clu ster display. If one of t he pieces of
drive r informa t ion is tu rned
Off , that dr iver infor -
mation will not be shown in the disp lay. The in-
formation will cont inue to be ca lculated by the
trip computer and can be turned back
On at any
t ime .
(D Tips
- This function is not available o n all vehicles.
- The d riving info rmation in the efficiency
prog ram * is also reset to zero with t he sin-
gle-trip memory.
21
To Next Page
Loading...
