CD
CD
....
N
,-...
N
.....
0
0
c:<:
00
The driver message disappears after a few sec-
onds. The driver message can be disp layed again
by briefly pressing the
!SET! button .
Red symbols
Fig. 22 Display: Danger symbol
With a priority 1 malfunction, a red symbol ap -
pears in the upper center area of the display
0
~
"'
9
a:
CX)
IX)
c:::> fig . 22 . A driver message appears as well to ex-
plain the ma lfunction in more deta il. When this
symbol appears,
three warning tones sound in
succession. The symbol continues to flash until
the fault has been corrected .
If
several pr iority 1 malfunctions are present, the
symbols appear in succession and remain for
about 2 seconds .
The driver warning goes out after about 5 sec-
onds, but it can be brought up again at any time
by pressing the
ISETI button c:> page 24.
Alternator failure
c:::> page 2 5
Electromechanical steer ing
c:::> page 191
USA models : Brake system
malfunction
c:>page 25
Canada models: Brake system
malfunction
c:> page 25
Eng ine coolant level too low/
engine coolant temperature
too high
c:::> page 2 6
Engine oil pressure too low
c:::> page 2 7
Driver information system
Refill engine oil now
c:::> page 2 7
Refill Ad Blue*
c:>page 214
AdBlue malfunction*
c:::> page 214
Steering malfunction
c:::> page 2 7
Ignit ion lock malfunction
c:>page 27
Hybrid drive*
c:> page 102, c:> page 107
' 0 Alternator malfunction
If the . symbo l in the instr ument panel display
flashes, then the re is a ma lfunction in the alter-
nator or the vehicle electronics . A warning to the
driver will appear, too . The driver warning goes
out after about 5 seconds, but it can be brought
up at any t ime by pressing the
!SET! button aga in.
Usually, you can sti ll drive to the next dea lership .
Turn off all but the most necessary electrica l con-
sumers, since these drain the vehicle's battery.
(D Note
If the . warning symbo l (coolant system
malfunction) also lights up on the instrument
panel during the trip
c:> page 26, then you
have to stop immediately and turn off the en-
gine. The coolant pump is not working any-
more - danger of damage to the engine!
BRAKE/C(D) Brake system malfunction
A ma/function in the brake system must be re-
paired as soon as possible .
If the warning/indicator light 11111 (USA mod-
els). (Canada models) in the instrument clus-
ter flashes, there is a brake system malfunction.
A driver message appears as well to explain the
malfu nction in more detail. The driver wa rn ing
goes out after about 5 seconds, but it can be
brought up at any time by pressing the
ISETI but-
ton again. ..,.
25
To Next Page
Loading...
