Opening and closing
Rolling code programming
Applies to: vehicles with garage door opener (Homeli nk)
Rolling code programming is also needed for
some systems.
Identifying a rolling code
"' Press and hold the button in the roof headliner
that was already programmed .
"'Watch the LED@ c:> page 46, fig. 43. If the LED
blinks quickly, the systems (such as a garage
door) is equ ipped with a rolling code.
"' Program the rolling code as follows:
Activating the motor unit in a system
"' Locate the programming button on the sys-
tem's motor unit. The exact location and color
of the button may vary depending on the brand
of the system .
"'Press the programm ing button on the garage
door opener motor unit (th is will usually acti-
vate an "indicator" on the moto r unit). You now
have approximate ly
30 seconds to program the
button in the roof headliner.
Programming the button in the roof
headliner
"' Press and hold the previously programmed but-
ton in the roof headliner for 2 seconds .
"'To end rolling code programming, press and
hold the button again for two seconds .
"'With some systems, the button may need to be
pressed a third time to end the programming
process .
After programming, the system should detect
the signal and begin moving when the button in
the roof headliner is pressed . Now you may pro-
gram the other buttons as needed .
(D Tips
- The rolling code can be programmed more
quickly and more easily with the help of a
second person.
- If you have difficulty programm ing the roll-
ing code, referring to the user guide for the
system may help.
48
To Next Page
Loading...
