EasyManua.ls Logo

Audi R8 Spyder 2011 - Page 133

Audi R8 Spyder 2011
244 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
A WARNING
1
Improper care, servicing and repair proce-
dures can increase the risk of personal in-
jury and death by preventing an airbag
from deploying when needed or deploying
an airbag unexpected ly:
- Never cover, obstr uct, or change the
steering wheel horn pad or airbag cover
or the instr ument pane l or modify them
in any way.
- Never attach any objects such as cup
holders or t elephone mountings to the
surfaces covering the airbag units .
- For cleaning t he horn pad or inst rumen t
pane l, use only a soft, dry cloth or one
moistened with plain water . Solvents or
cleaners could damage the airbag cover
or change the stiffness or strength of the
material so that the airbag cannot de-
ploy and protect properly.
- Never repai r, adjust, or change any parts
of the airbag system.
- All work on the stee ring wheel, instru-
ment pane l, front seats or electrical sys-
tem (including the installation of aud io
equipment, cellular telephones and CB
radios, etc.) must be performed by a
qualified technician who has the training
and special equipmen t necessa ry.
- For any work on the airbag system, we
st rongly recommend t hat you see your
authorized Audi dealer or qualified work-
shop.
- Never mod ify the front bumper or parts
of the vehicle body.
- Always make sure that the side airbag
can inflate witho ut interferen ce:
- Never insta ll seat covers or replace-
ment upholstery over the front seat-
backs that have not been spec ifically
approved by Audi.
- Never use add itiona l seat cushions that
cover the areas where the side airbags
inflate.
- Damage to the origina l seat covers or
to the seam in the area of the side air-
bag module must always be repa ired
A irbag sys tem 13 1
immediately by an author ized Audi
dealer.
- The airbag system can be activate d only
once. After an airbag has inflated, it
must be replaced by an authorized Audi
dea ler or qualified technician who has
the technical information , t raining and
special equipment necessary .
- The airbag system can be deployed only
once. After an airbag has been deployed,
it must be replaced with new replace-
ment parts designed and approved espe-
cially for your Audi model version. Re-
placemen t of complete airbag systems
or airbag components must be per-
formed by qualified workshops only.
Make sure that any airbag service action
is entered in your Audi Warranty
& Main-
tenance booklet under
AIRBAG REPLACE-
MENT RECORD.
- For safety reasons in severe accidents,
the alternator and starter are sepa rated
from the vehicle battery with a pyrotech-
nic circuit inte rrupte r.
- Work on the pyrotechnic circuit inte r-
rupter must only be performed by a
qualified dea ler - risk of an accident!
- If the vehicle or the circuit interr upter
is scrapped, all applicable safety pre-
cautions must be followed.
@ For the sake of the environment
Undeployed airbag modules and preten-
sioners might be classif ied as Perchlorate
Material - specia l hand ling may apply, see
www.dtsc .ca. gov/hazard o u swaste/ per-
ch [orate. When the vehicle or parts of the
restraint system including airbag modules
and safety belts with pretensioners are
scrapped, all app licable laws and regu la-
tions must be obse rved. Your authorized
Audi dealer is familia r with these require-
ments and we recommend that you have
your dealer perform this service for you.

Table of Contents

Related product manuals