Page -15-© Audient Ltd
Networking (Mac)
Once you have connected ASP2802 to your studio computer
via either a direct Ethernet link or through a router and installed
AuNet you are ready to set up the networking side of the
console.
IP Address Setup for Direct Connection
Unless you have a router in your studio, it is most likely that you
will directly connect ASP2802 to your DAW via a direct Ethernet
link.
First you must set your DAW IP address (please note if you do
have a router, this should not be adjusted and you should skip to
the next section).
On Apple computers please do the following:
System Preferences > Network > Ethernet Tab > Locations
> Edit Locations > Add New Location (+ Button) > Name
ASP2802 > Select this Location > Set Configure to Manually
> Set IP Address to 192.168.0.1 > Set Subnet Mask to
255.255.255.0
To Next Page
Loading...