Setting The Clock Source
Once you have connected your external devices to ORIA as per the example
diagrams, you will need to instruct ORIA where to take its clock from. This is done
in the System Panel of the ORIA software. More information regarding this can be
found in the System Panel section of the manual.
Network Audio
ORIA can be fitted with the Optional Dante Card, which will provide 16 inputs to allow
ORIA to provide Immersive Monitor Control to a Dante Audio Network.
At the time of writing this manual, the Optional Dante Card is not yet available.
Additional information will be provided on the implementation and use of this card
upon its release in the near future.
USB
You can connect ORIA with your chosen computer via USB-C. If your computer doesn’t
have a USB-C port, then a third party USB-C to USB-A cable should be used instead.
To Next Page
Loading...
