Why does my Audio Analogue Crescendo Amplifier remote controller not work?
The remote controller might not be working because it has no battery or the battery is worn out. Try placing or replacing the batteries with two new ‘AAA’ batteries.
What to do if my Audio Analogue Crescendo has no LED and no sound?
First, ensure the power cord is correctly plugged into the wall outlet. If the issue persists, after unplugging the power cord from the wall outlet, check the fuses in the fuse panel above the IEC inlet and replace them with new ones of the same type if they are burned-out.
What to do if only one input LED is on and there is no sound from my Audio Analogue Crescendo?
There are several possible reasons for this issue: 1. The volume might be too low, so turn the volume knob to the right. 2. There might be faulty or incorrectly plugged signal connectors between the amplifier and the sources. Inspect the cords and their connections. 3. The source might be off or incorrectly selected. Make sure the source is on and active, and correctly selected using the input selector. 4. There might be faulty or incorrectly plugged power cords between the amplifier and the speakers. Check the cords and their connections.
What to do if recording is impossible on Audio Analogue Crescendo?
If recording is impossible, ensure that you have selected the correct source using the recording selector and that the volume is above 0.
Why are selected input LEDs on, but volume control LEDs are off (or vice versa) on my Audio Analogue Crescendo?
This issue may occur if you are standing too far away or at too extreme of an angle from the front panel. Try getting closer to the unit or reducing the angle.
Explains the function of each button, knob, LED, and input on the front panel.
Identifies speaker outputs, line inputs, REC OUT, Trigger IN, power inlet, and fuses.
Details how to use the remote for volume, input selection, mute, and setup functions.
Lists symptoms, causes, and remedies for operational problems.
Procedures for EU residents to properly dispose of the device.
Instructions for non-EU residents on correct disposal methods.
Procedures for EU businesses for take-back and recycling of the product.
Instructions for non-EU businesses on correct disposal methods.
General| Brand | Audio Analogue |
|---|---|
| Model | Crescendo |
| Category | Amplifier |
| Language | English |
To Next Page