9
Listening to audio
• To connect for the first time, pair the product and your device by Bluetooth wireless technology. If you have already paired
the product and your Bluetooth device, turn on the Bluetooth device’s Bluetooth connection and turn on the product.
• Use your Bluetooth device to start playback, referring to the device’s user manual as necessary.
Power supply/control button
Press Play/pause Plays or pauses music and video. *¹
Volume buttons
+ button
Press Volume up Increases the volume by 1 level. *²
Press and hold
(for about 1 second)
Skip forward Plays the next track. *¹
− button
Press Volume down Decreases the volume by 1 level. *²
Press and hold
(for about 1 second)
Skip back Plays the previous track. *¹
*1 Some controls may not be available for music and video playback on some devices.
*2 A confirmation tone is heard when the volume is at the maximum or minimum level.
• The volume control of some devices may not work well with the product.
Using hear-through mode
• In the hear-through mode of the product, the ambient sound is audible through the built-in microphone even with the
headphones on.
• The ambient sound may at times be hard to discern depending on the volume of the music you are playing. In that
case, turn down the volume of the music.
• Even in the hear-through mode of the product, the ambient sound may be less audible due to the ambient
environment. Do not use the product in an area where it might be dangerous if the ambient sound is hard to discern,
such as places with a lot of traffic.
• With the hear-through mode on, the volume of music automatically turns down to capture the ambient sound.
• If you turn the hear-through mode on or off when the volume is at the maximum or minimum level, the confirmation
tone will sound repeatedly. This is not a product failure.
• The hear-through mode may not be activated at certain times, such as when you turn on the power of the product
while touching the touch sensor, or when the usage environment is not agreeable. In these cases, cycle the power of
the product, allowing more than five seconds between turning off and on.
To turn the hear-through mode on, touch the touch sensor
located in the center of the left headphone (L).
- To turn it off, touch the touch sensor again.
- The confirmation tone will sound once when the hear-through mode
turns on, and twice when it turns off.
Touch sensor
“L” (left) side
Using the product
To Next Page
Loading...
