14
SBC priority connections (for when sound is delayed significantly)
When the connection codec is AAC, significant sound delays can be alleviated by changing the connection codec to
SBC, which comes standard with Bluetooth devices.*¹
Connecting to a SBC priority connection
When the pairing with a Bluetooth device has been completed
1. Disconnect the communications with the Bluetooth device, and keep the product from connecting via Bluetooth.
2. Turn the product power to “ON”.
3. With the indicator lamp showing the searching for device status, press and hold the + and - volume buttons
simultaneously (for about 1 second).
• The indicator lamp will flash in purple.
4. Resume communication with the Bluetooth device while the indicator lamp is flashing in purple.
• If the indicator lamp changes to flashing three times in blue, the settings are complete.
Before pairing with a Bluetooth device
1. Turn the product power to “ON”.
2. With the indicator lamp showing the searching for device status, press and hold the + and - volume buttons
simultaneously (for about 1 second).
• The indicator lamp will flash in purple.
3. With the indicator lamp flashing in purple, refer to steps 2 and 3 of “Pairing a Bluetooth device” (p.7) to perform the
pairing operation.
• If the indicator lamp changes to flashing three times in blue, the settings are complete.
• After pairing via an SBC priority connection is complete, the only available connection codec will be SBC.
Connections using other codecs will not be possible.*²
• For details on the flashing and lit displays of the indicator lamp, refer to “Indicator lamp display” below.
*1 Depending on the usage environment, changing to an SBC priority connection may not alleviate sound delays.
*2 Turning the power off and then turning it back on will result in a return to a normal connection and enable connections using other
codecs. Please connect using an SBC priority connection when necessary.
Troubleshooting
Indicator lamp display
The indicator lamp of the product indicates the product's status as explained below.
Status
Indicator lamp display pattern
Red Blue Purple
Pairing
Searching for device
Flashing
Searching for device (when using
an SBC priority connection)
Connection
Connecting
Connecting (when using an SBC
priority connection)
Battery level Battery level low
The blue indicator lamp for the pairing and connecting statuses
changes to a red indicator lamp.
Charge
Charging
Lit
Fully charged
Off
To Next Page
Loading...
