6
Charging the headphones and charging case
• Fully charge the battery when using for the first time.
• If the rechargeable battery power is running low, the product will beep through the headphones, and the indicator
lamps of the headphones will flash in red. When these beeps sound, charge the battery.
• It takes approximately two hours to fully charge the headphones, and approximately three hours to fully charge the
charging case. (This time may vary depending on usage conditions.)
1. Connect the included USB charging cable (micro USB Type-B side) to the battery jack of the charging case.
• The included USB charging cable is designed for exclusive use with the product. Do not use any other USB
charging cable.
• When inserting the USB charging cable into the USB port or battery jack, check that the connector is facing in the
correct direction before inserting it directly (horizontally).
2. Connect the included USB charging cable (USB Type-A side) to the computer to start charging the charging case.
Computer
Battery jack
Micro USB Type-B
USB Type-A
USB charging cable
(Included )
USB port
• During charging, the charging indicator lamp (for the charging case) lights on the rear of the charging case as
follows:
Charging state of
charging case
Charging indicator lamp
Red Blue
Charging indicator lamp
(for the charging case)
Light pattern
Charging Lit red
Charging
complete
Lit blue
Charging failure Flashing red
Charging the battery
To Next Page
Loading...
