Assistent 30 integrated tube amplifier__________________________________
strands of wire short across to the other terminals or the amplifier chassis. When using plugs such
as Banana, be sure to use good quality one`s with a firm fit.
Please remember that the AUDIOVALVE Assistent 30 amplifier is a high quality electronic
instrument capable of an exeptional level of performence.
PLACEMENT AND VENTILATION
This AudioValve ASSISTENT 30 amplifier is designed to
operate at a moderately high temperature. The ideal location
is on the rigid stand or floor mounted away from direct contact with any objects, materials or deep
pile carpets which may be effected by the heat or which may interrupt the flow of air around the
amplifier.
When operating the amplifiers quite a lot of heat is generated which should be allowed to dissipate
without restriction. Make sure that no objects are placed on the top of the amplifier. Always ensure
adequate ventilations.
INSTALLATION AND OPERATION
MAIN VOLTAGE
and Main Power Plug ( fuse ) and Main Switch
MAIN POWER connection is via supplied plug-in lead. The standard IEC socket connects the mains
power at the amplifier end while a local mains plug is required at the wall end. In the event where
a "local" plug needs to be fitted to the wall end of the lead, ensure that the plugs is wired correctly
by a suitable qualified or experienced person.
Ensure the amplifier is disconnected from the main voltage before attempting any
modification of the main connection.
The heavy square duty rocker switch for the main voltage ON /OFF is located on the front panel.
The main fuse is next to the main plug, the value is 3,15 amp sb. for 115VAC or 1,6 amp. sb as for
230VAC.
DO DISCONNTECT the main power cord from the voltage when you check the fuse !
MAINS VOLTAGE
CHECK that the mains voltage printed on the rear of this
amplifier is similar to the mains voltage normaly supplied to
your area. If in doupt, please consult your AUDIOVALVE dealer.
Please notice that you never exceed the mains voltage in the prescribed value shown at the lable of
the serial number on the rear side. If you can`t provide the amplifier with the exact shown main
voltage, please use a voltage stabilizer - particulare for the US and Mainland China marcet.
To Next Page
Loading...