Need help?Do you have a question about the AudioBahn DUB100 and is the answer not in the manual?
Lists key woofer components like DUAL 4 OHM COIL, HIGH EXCURSION SUB, sticker, manual, and wipe towel.
Describes the polished chrome steel stamped basket for perfect alignment on each woofer.
Describes KM3 coated laminated paper cone for rigidity, strength, and reduced distortion.
Provides consistent support for linear motion and damping, improving frequency response clarity.
Balances linear compliance for symmetrical voice coil control, reducing distortion.
Describes durability and protective metal finish, enhancing aesthetics for enclosures.
Increases cone rigidity and power handling by forcing air through the voice coil.
Black anodized aluminum former for efficient thermal transfer and improved efficiency.
Provides a more linear magnetic field for operation, lowering distortion.
Stepped deeper for more excursion and vented for efficient cooling.
4-layer, edge wound voice coil design for various impedance loads.
Table of parameters like Fs, Qts, Qes, Qms, Vas, Re, Le, Mmd, Xmax, RMS, Sd, Freq. Resp., Efficiency.
Table detailing Depth, Hole, Diameter, and Displacement for DUB models.
EBP values for each model, with suggestions for sealed or ported box types.
Box specifications for Ported (Space Saver, Everyday, Ultimate SPL) and Sealed designs.
EBP values and their interpretation for choosing between sealed and ported boxes.
Minimum and maximum sealed box volume recommendations per model.
Normalized amplitude response graph for DUB100 in a Space Saver enclosure.
Normalized amplitude response graph for DUB100 in an Everyday enclosure.
Normalized amplitude response graph for DUB100 in an Ultimate enclosure.
Normalized amplitude response graph for DUB200 in a Space Saver enclosure.
Normalized amplitude response graph for DUB200 in an Everyday enclosure.
Normalized amplitude response graph for DUB200 in an Ultimate enclosure.
Normalized amplitude response graph for DUB500 in a Space Saver enclosure.
Normalized amplitude response graph for DUB500 in an Everyday enclosure.
Normalized amplitude response graph for DUB500 in an Ultimate enclosure.
Guidance on building rigid enclosures using MDF and internal bracing.
Formula for calculating box volume and accounting for internal displacement.
Explains passive/active crossovers, recommending an 80-100Hz low pass crossover.
Steps to check connections, enclosure integrity, and components for sound issues.
Check amplifier, source unit, and other processors if the problem persists.
Caution when drilling, working near lines, securing system, protecting wires.
Fuse +12V DC power wire at battery; use correct fuse rating.
Specifications are subject to change without notice.
Contact Audiobahn, local dealer, or website for information.
Manufacturer defects only, one year, requires receipt from authorized dealer.
Covers defective subs, plexiglass, neon; requires RA# for returns.
Excludes damage from abuse, misuse, improper installation, unauthorized services.
Confirm defect, contact dealer/Audiobahn, obtain RA#.
Acquire RA#, mark carton clearly; shipping costs are consumer's responsibility.
Audiobahn Headquarters contact information.
To Next Page
General