AudioCodes Mediant 2600 Quick Setup Guide

3 | Page
Physical Description of Rear Panel
1
AC power supply inlet (100-240V~2.5A, 50-60 Hz) for Power Supply module #1.
2
AC power supply inlet (100-240V~2.5A, 50-60 Hz) for Power Supply module #2.
3
Electrostatic Discharge (ESD) lug.
4
Protective earthing (grounding) screw.
Mounting the Device
You can mount the device on a desktop using the four anti-slide bumpers (supplied), which you need to stick on
the grooves located on the underside of the device.
You can also mount the device in a standard 19-inch rack, by placing it on a pre-installed rack shelf (not
supplied), and then securing the device to the rack frame using front-mounting brackets (supplied).
For additional 19-inch rack mounting options, refer to the Mediant 2600 E-SBC Hardware Installation Manual.
Powering Up the Device
The device is powered from a standard alternating current (AC) electrical wall outlet. The device provides two
hot swappable, power supply modules for power load sharing and 1+1 AC power redundancy in case of failure
of one of the modules.
 If you are using both Power Supply modules, ensure that you connect each one to a different AC power
supply source. The two AC power sources must have the same ground potential.
 The device must be connected (by service personnel) to a socket-outlet with a protective earthing
connection.
1
2
3
4

AudioCodes Mediant 2600 Specifications

General

Brand	AudioCodes
Model	Mediant 2600
Category	Controller
Language	English