Page 1 of 17
AudioCodes™ MP-100/104 Gateway Quick Start Installation Guide
March 2004
AudioCodes™ MP-100/104 Gateway
Quick Start Installation Guide
INTRODUCTION
This quick start guide contains information about how to install and configure the Audio-
Codes™ MP-100/104 Gateway. Although this guide covers both the MP-100 and MP-104
Gateways, the installation instructions apply to the MP-104. This gateway is the latest version
that is available through the Inter-Tel
®
CommSource™ division. For details about the MP-100,
refer to the latest version of the IP Devices Manual.
SYSTEM REQUIREMENTS
The following lists the system requirements for installing the AudioCodes MP-100/104 Gate-
way:
• Internet Protocol Resource Card (IPRC) firmware v1.3 or later
NOTE: To support Session Initiation Protocol (SIP) on the AudioCodes MP-100/104
Gateway, v1.5 or later firmware is required.
• Axxess
®
v7.0 or later
SYSTEM DATABASE PROGRAMMING
The IPRC firmware version determines how Axxess is programmed to support the gateways.
For details about system database programming, refer to the documents listed below.
If you are installing the gateway on a:
• V1.x firmware IPRC, see the latest version of the IP Devices Manual.
• V8.x firmware IPRC, see the Addendum to the v8.0 Installation and Maintenance Man-
ual.
AUDIOCODES MP-100 GATEWAY INSTALLATION
For details about installing the AudioCodes MP-100, refer to the latest version of the IP
Devices Manual.
Document Part Number 835.2741-3
A946/3852A
© Inter-Tel, Inc. March 2004 printed in USA
To Next Page
Need help?
General
