Need help?Do you have a question about the AudioCodes MP-112 and is the answer not in the manual?
General| Model | MP-112 |
|---|---|
| Category | Gateway |
| Ports | 2 FXS ports |
| Network Interface | 10/100 Base-T Ethernet |
| Ethernet Ports | 1 |
| Protocols | SIP, H.323 |
| Operating Temperature | 0°C to 40°C |
| Humidity | 10% to 90% non-condensing |
| Voice Codecs | G.711, G.723.1, G.726, G.729A |
| Management | SNMP |
| Security | SRTP, TLS, HTTPS |
| Fax Support | T.38 |
| Power Supply | 12V DC |
| Storage Temperature | -20°C to 70°C |
Details the physical size, weight, and environmental conditions for the MP-11x.
Describes the LEDs on the front panel of the MP-11x and their meanings.
Details the rear panel layout and describes each port and connector.
Identifies the components on the underside of MP-11x used for mounting.
Instructions for placing the device on a flat surface using anti-slide bumpers.
Procedure for securing the device to a wall using keyholes and screws.
Guide for installing the MP-11x in a standard 19-inch equipment rack.
Details essential steps for protecting the device from power surges and proper grounding.
Instructions for connecting the MP-11x to a network via its Ethernet port.
Procedure for connecting analog telephones or devices to the FXS ports.
Guide for connecting the MP-11x to CO/PBX lines via FXO ports.
Details how to connect a lifeline phone for use during power or network outages.
Instructions for establishing serial communication with the MP-11x via its RS-232 port.
Provides instructions and specifications for powering the MP-11x device.
To Next Page