AudioCodes MP-112 User Manual

Hardware Installation Manual 6 Document #: LTRT-59824
MP-11x
Related Documentation
Document Name
SIP Release Notes
MP-11x & MP-124 SIP User's Manual
MP-11x SIP Fast Track Guide
Notes and Warnings
Warning:
Read and adhere to all warning statements in this document before
installing the device.
Warning: The MP-1xx device is an indoor unit and therefore, must be installed only
INDOORS.
Warning: Routing of FXS telephony cables outdoors can be done only in conjunction
with AudioCodes’ approved surge protector (Circa model 4B3S-
75) and proper
installation and grounding. When done correctly, the installation will meet ITU-T K.21
basic level. For more information, see Section 5.1 on page 23.
Warning: The Ethernet port interface cabling must be routed only indoors and must
not exit the building.
Caution Electrical Shock
Do not open or disassemble this device. The device carries high voltage and contact
with internal components may expose you to electrical shock and bodily harm.
Warning: The device is supplied as a sealed unit and must only be serviced by
qualified service personnel.
Warning: Before servicing the device, disconnect the device from the mains and from
the telephone network cabling.

AudioCodes MP-112 Specifications

General

Model	MP-112
Category	Gateway
Ports	2 FXS ports
Network Interface	10/100 Base-T Ethernet
Ethernet Ports	1
Protocols	SIP, H.323
Operating Temperature	0°C to 40°C
Humidity	10% to 90% non-condensing
Voice Codecs	G.711, G.723.1, G.726, G.729A
Management	SNMP
Security	SRTP, TLS, HTTPS
Fax Support	T.38
Power Supply	12V DC
Storage Temperature	-20°C to 70°C