Audiofront eDrumin 10 - Using a Roland BT-1

Using a Roland BT-1
eDRUMin$85%B
28,$28,$5
=
Sensor Mode
5528,!>(5(5
$$528,
Note:!528,J'BJ'B>28,(

Xtalk Mode
!5(28,(>(1(D1
628,5(B
!D1>28,$
Link to Input
7D1>(128,6
5(28,1>5
$
71?(>(1$H>28,
5$($>(2<7
#$H
Adjusting Crosstalk Cancellation To Linked Input
<2,1>11
2,>>19511
   5 6 5  ,   $   5     (   
11= $(51(
(
eDRUMin Manual Page 24 of 49
BT-1 setup on a
stereo input
Switch between 'Sensor'
and 'XTalk' modes
1
Make sure the BT-1 is in Xtalk mode.
2
Click 'Link to Input'
3 Select the input to link the BT-1 to.
3 When linked and the BT-1
is selected, both inputs will
be highlighed in orange.