Audiofront eDrumin 10 - Connecting Drum Pads; Loading a Pad Preset

Connecting Drum Pads
,0E5565
'1((%
61#65(
?>(%$
($6%!5($5/8
(>;$39>
(52<70##J%/8K%B
($1J2B
!    $       

$<>55
65
Loading a Pad Preset
:5($(1'!
!55(6$>(B($(
(;
*155$'
eDRUMin Manual Page 9 of 49
For ED10 , the BOW / EDGE connector
should be plugged into the top input,
and the BOW / BELL on the bottom.
For ED4 , the BOW / EDGE connector
should be on left, and the BOW / BELL
should be on the right.
Select an input
Filter presets
by brand
Filter presets
by type
Open the
Preset Manager
1 2 3
Double-click a preset to load it
Change to Input to Dual Mono to split the input