Audiofront eDrumIn 4 - Setting up VH-12 and Hall Effect Sensors

Setting up VH-12 and Hall Effect Sensors
Roland VH-12
'%$(>648,.$5
L$1(>48,.5(
($$
Hall
Effect Sensors
eDRUMin  $   =   7   5
(    =  > (   1(     
(
Self-Powered
!5(=59(>($
(%>;1548,.$6
Requires Power From Jack
!5(=5e DRUMin>(
$J#9B<*%!:55

*15=
eDRUMin Manual Page 34 of 49
Click to calibrate
Use your mouse to adjust the sides of the
green rectangle.
Change the pedal
polarity to 'Roland'
Set pedal type
to hihat
1
2
3
4
Set the pedal type
to expression pedal
1
Set the polarity
1
If the polarity is set to Roland, the ring will recieve 3.3v
If the polarity is set to Yamaha, the tip will recieve 3.3v