Important Safety Information
Being Roon Ready means that 9000N uses Roon streaming
technology, for an incredible user interface, simple setup,
rock-solid daily reliability, and the highest levels of audio
performance, without compromise.
MQA (Master Quality Authenticated)
MQA is an award-winning British technology that delivers the
sound of the original master recording. The master MQA file
is fully authenticated and is small enough to stream or down-
load. Visit mqa.co.uk for more information. 9000N includes
MQA technology, which enables you to playback MQA audio
files and streams, delivering the sound of the original master
recording.
MQA and the Sound Wave Device are registered trademarks
of MQA Limited ©2016
The Audiolab 9000N MQA on-screen indicator glows green or
blue to indicate that the unit is decoding and playing an MQA
stream or file,and denotes provenance to ensure that the
sound is identical to that of the source material. It glows blue
to indicate it is playing an MQA Studio file, which has either
been approved in the studio by the artist/producer or has
been verified by the copyright owner
FCC Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by
manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
• RF Exposure Information
• The device has been evaluated to meet general RF exposure requirement.
• The device can be used in portable exposure condition, compliance with expo
sure requirements.
ISED Statement
This device contains license-exempt transmitter(s)/receiver(s) that comply with
Innovation, Science and Economic Development Canada’s licence-exempt RSS(s).
Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may
cause undesired operation of the device.
The digital apparatus complies with Canadian CAN ICES-3 (B)/NMB-3(B).
This device meets the exemption from the routine evaluation limits in section 2.5
of RSS 102 and compliance with RSS 102 RF exposure, users can obtain Canadian
information on RF exposure and compliance.
This equipment complies with Canada radiation exposure limits set forth for an
uncontrolled environment.
The device has been evaluated to meet general RF exposure requirement. This
equipment should be installed and operated with a minimum distance of 20mm
between the radiator & your body.
To Next Page
Loading...