Audiolab DSP-2600 - Input Gain Setting; Input EQ Setting

DSP-2600
P.
8
ENGLISH VERSION
4.InputGainSetting:
 ParameterGain, adjust range: -40.0dB-+6.0dB,
Step pitch is 0.1dB. Each channel has unat-
tached gain control.
Example
1. PressA channel key about 3seconds till the
yellow light display, into EditStatus.
2. Press “<BACKor“NEXT>”, switch to Gain.
Displaynext:
3. Turn the rst knob of “PARA” to change the value.
(Turn the knob clockwise, the value increase:
Turn the knob withershins, the value decrease.)
5.EQsetting:
 ParameterEQ,INA-IND Each channel can set 8
parameter EQ(EQ1-EQ8).
A: At parameter status:
Freq: 20Hz-20KHz
Gain: -30dB-+15dB
Bandwidth: 0.05/Oct-3/Oct
B: At Lo_Shelf, Hi-shelf status:
Freq: 20Hz-20KHz
Gain: -30dB-+15dB
Bandwidth: 0.05/Oct-3 /Oct
Example
1. PressA channel key about 3 seconds till the
yellow light display, into EditStatus.
2. Press “<BACKor“NEXT>”, switch to EQ, into
“Parameter” setting status.
Displaynext:
3. Turn the rst knob of “PARA”, switch to “Lo--
 shelf”or“Hi-shelf” setting status, Press EN-
TER to conrm.
Displaynext: