Audiolab DSP-4800 - Output Parameter Setting; Polarity and Delay

DSP-4800
P.
11
ENGLISH VERSION
4.OutputPolaritySetting:
 ParameterPolarity, +Normal:Positive, -Invert:
Negative pole. Each channel has unattached
phase control.
Example
1. PressOUT1 channel key about 3 seconds till the
yellow light display, into EditStatusofOUT1.
2. Press “<BACKor“NEXT>”, switch to Polarity.
Displaynext:
5.OutputDelaySetting:
 Parameter Delay, adjust range: 0ms-1000ms,
0Meter-346Meter, 0Feet-1134.88Feet. Each chan-
nel has unattached delay control.
Example
1. PressOUT1 channel key about 3 seconds till the
yellow light display, into EditStatusofOUT1.
2. Press “<BACKor“NEXT>”, switch to Delay.
Displaynext:
3. Turn the rst knob of “PARA” to ne adjust-
ment. Turn the second knob to rough adjustment.
(Turn the knob clockwise, the value increases; Turn
the knob withershins, the value decreases).