Need help?Do you have a question about the Audiopipe APNK-7002 and is the answer not in the manual?
Audio Performance| RMS power at 4 Ohm | 2 х 700W |
|---|---|
| MAX power at 4 Ohm | 2 х 1400W |
| Bridged power at 4 Ohm | 1 х 2800W |
| RMS power at 2 Ohm | 2 х 1050W |
| Minimum speaker impedance | 2 Ohm |
| Total Harmonic Distortion (THD) | 0.04% |
| Frequency response | 10Hz ~ 35kHz, -1dB |
| Input sensitivity | 200mV-8V |
| Signal to noise ratio | >100dB |
| Channel separation | >60dB |
| Low pass filter crossover | 50Hz ~ 120Hz |
| High pass filter crossover | 50Hz ~ 750Hz |
| Bass boost control | 0 ~ +18dB |
Dimensions and Physical| Dimensions (W х H х D) | 299 х 74 х 637 mm |
|---|---|
| Fuse | None |
Audio Performance| RMS power at 4 Ohm | 4 х 250W |
|---|---|
| MAX power at 4 Ohm | 4 х 500W |
| Bridged power at 4 Ohm | 2 х 1000W |
| RMS power at 2 Ohm | 4 х 350W |
| Minimum speaker impedance | 2 Ohm |
| Total Harmonic Distortion (THD) | 0.04% |
| Frequency response | 10Hz ~ 35kHz, -1dB |
| Input sensitivity | 200mV-8V |
| Signal to noise ratio | >90dB |
| Channel separation | >50dB |
| Low pass filter crossover | 50Hz ~ 120Hz |
| High pass filter crossover | 50Hz ~ 750Hz |
| Bass boost control | 0 ~ +18dB |
Dimensions and Physical| Dimensions (W х H х D) | 299 х 74 х 588 mm |
|---|---|
| Fuse | None |
To Next Page
