MATRIX | Modulation matrix + Operators (lag + mult)
Pressing the MATRIX button will alternate between the Mod matrix and the Lag operator view
Modulation matrix
The modulation matrix allows you to apply a modulation source (an enveloppe or a LFO for example) to
a selection of synthesis parameters.
There are 10 modulation matrix slots per program.
M01 Src:lfo1*whl
Dst:ptch Amt: +8
In mod matrix view, the encoders control the following parameters :
1. Mod matrix slot selection (1 to 10)
2. Mod matrix destination
3. Mod matrix source
4. Mod matrix amount
NOTE : Mod matrix amount is a bipolar value (-99 to +99) and its behavior in not linear (by design).
It allows subtle modulations in lower values, so if you want a drastic change, do not be afraid to push the
value:)
Lag operator
Lag operator allow you to « slow » a modulation source, and use the result as a modulation source in the
modulation matrix.
For example, « Lagging » a square LFO will round its edges for a less abrupt changes between states.
OPS Src:lfo1*vel
Lag Amt: 25
In Lag operator view, you control :
1. OP selector
2. N/A
3. Lag source
4. Lag level
Audiothingies MicroMonsta 2 user manual v2.1 22
To Next Page
Loading...