Page 8
ELIMINATING THE NORMAL ARM / DISARM CHIRPS
As explained earlier in the manual, you can eliminate the chirps selectively any time you
arm or disarm the system simply by holding the ARM / DISARM button for two seconds. If
you find the normal arming and disarming chirps annoying, they can be turned off perma-
nently, eliminating the need to hold the ARM / DISARM button for two seconds. To do this,
1. Start with the valet switch in the off position, then turn the ignition key on then off.
2. Within 10 seconds, move the valet switch to on then off three times.
3. If the chirps were on before you started, then you will hear 2 chirps indicating
they have been turned off.
If the chirps were off before you started, then you will hear one chirp indicating they
have been turned on.
NOTE : Whenever the chirps are by - passed, the 4 chirp intrusion indicator and 3 chirp
defective zone indicator will always operate. Since these are important warnings to you that
something has happened, they cannot be eliminated.
REMOTE PANIC OPERATION
The ARM / DISARM button on your keychain transmitter also functions as a panic switch for
use in emergency situations. To use remote panic,
1. Press and hold the ARM / DISARM button on the keychain transmitter for 3 or
more seconds. The alarm will immediately sound.
2. To stop the alarm, press and hold the ARM / DISARM button on the transmitter
again for 3 seconds. If the button is not pressed, the alarm will automatically stop
after 30 seconds.
NOTE : All normal transmitter functions will operate in the panic mode.
ADDITIONAL REMOTE FUNCTION ( CHANNEL 2 )
This security system has an additional feature that can be connected to a number of differ-
ent optional accessories. Some of the more common uses for this channel are;
Remote Trunk Release
Remote Car Starter
Remote Window Closure
Remote Garage Door Interface
To activate the optional accessory, press and hold button 2 on the keychain transmitter for
four seconds.
ADDITIONAL REMOTE FUNCTION ( CHANNEL 3 )
This security system has an additional feature that can be connected to a number of differ-
ent optional accessories. Some of the more common uses for this channel are;
Remote Trunk Release
Remote Car Starter
Remote Window Closure
Remote Garage Door Interface
To activate the optional accessory, press button 3 on the keychain transmitter. The op-
tional accessory will immediately engage.
To Next Page
Loading...
Need help?
General